Typical CAD Details
The following CAD details are intended to provide indicative guidance for common design-time scenarios.
For specific guidance on how best to integrate Rawell products into your designs, a technical service is available upon request.
You must be registered and logged-in to download these documents.
Petrochemical Lining CAD Details
- 01A - Upgrade for tank berm (411 Kb)
- 01B - Upgrade for tank berm (445 Kb)
- 02A - Pipe Penetration Through Earthen Bund Slope (330 Kb)
- 02B - Pipe Penetration Through Earthen Bund Slope (388 Kb)
- 03A - Bund Wall Termination (344 Kb)
- 03B - Bund Wall Termination (388 Kb)
- 04A - Cable Tray (335 Kb)
- 04B - Cable Tray (386 Kb)
- 05A - Cross Section Through Bund Floor (310 Kb)
- 05B - Cross Section Through Bund Floor (359 Kb)
- 06 - Earthen Bund 45 Degree Side Slope Detail (324 Kb)
- 07 - Earthen Bund Detail (336 Kb)
- 08A - Manhole Sealing (400 Kb)
- 08B - Manhole Sealing (442 Kb)
- 09A - Fixing to existing pipe support (340 Kb)
- 09B - Fixing to existing pipe support (371 Kb)
- 10A - Pipe Support Construction and Termination (361 Kb)
- 10B - Pipe Support Construction and Termination (407 Kb)
- 11A - Sealing to concrete ring beam (361 Kb)
- 11B - Sealing to concrete ring beam (403 Kb)
- 12A - Tank Berm Channel Construction (429 Kb)
- 12B - Tank Berm Channel Construction (470 Kb)
- 13A - Stair Support Construction and Termination (362 Kb)
- 13B - Stair Support Construction and Termination (408 Kb)
- 14A - Pipe Penetration Through Bund Floor (374 Kb)
- 14B - Pipe Penetration Through Bund Floor (429 Kb)
You must be registered and logged-in to download these documents.
Structural Waterproofing CAD Details
- 01 - Slab to Vertical Wall (Type P & S) (999 Kb)
- 02 - Sealing to Pile Caps (Type P & S) (898 Kb)
- 03 - Lift Pit Waterproofing Pre & Post Applied (Type P & S) (2,360 Kb)
- 04 - Stepped slab to wall transition (Type P & S) (967 Kb)
- 05 - Pipe Penetration through Wall (Type P & S) (932 Kb)
- 06 - Boxed Out Pipe Penetration to Wall (Type P & S) (1,006 Kb)
- 07 - Pipe Penetration to Floor Slab (Type P & S) (894 Kb)
- 08 - Boxed out Pipe Penetration to Floor Slab (Type P & S) (901 Kb)
- 09 - Sealing to sheet piles stages 1 - 8 (Type P & S) (2,551 Kb)
- 10 - Sealing to Contiguous and Secant piles (Type P & S) (891 Kb)
- 11 - Sealing to Contiguous or Secant Pile Wall Isometric View - Stages 1 - 5 (2,276 Kb)
- 12 - Sealing to RC Columns (Type P & S) (864 Kb)
- 13 - Sealing to Steel Column Base (Type P & S) (1,024 Kb)
- 14 - Leading Edge Protection Detail (Type P & S) (1,027 Kb)
- 15A - Horizontal & Vertical Overlap Detail (Type P) (2,003 Kb)
- 15B - Horizontal & Vertical Overlap Detail (Type S) (1,000 Kb)
- 15C - Overlap Detail (Slabseal) (438 Kb)
- 16 - Typical Termination Details at Ground Level (546 Kb)
- 17 - Typical Slabseal and Rawdrain Roof and Wall Detail (555 Kb)
- 18 - Podium Deck with Upstand detail (443 Kb)
- 19 - Roof Garden Upstand detail (420 Kb)
- 20 - Typical Drainage Cavity with Slab Waterproofing (461 Kb)
- 21 - Typical Wall & Slab Drainage Cavity (401 Kb)
- 22 - Slab to Wall Isometric Cut Away Detail (708 Kb)
Site Search
Advertisement
All information contained within this site is given in good faith and is correct to the best of Rawell Environmental Ltd.'s knowledge. However, this information is not legally binding and may be changed at any time without notice. Rawell offer a free advisory service, please Contact Us for more details. RAWMAT® and RAWSEAL® are registered trademarks of Rawell Environmental Ltd.